Cisco Cisco Packet Data Gateway (PDG) Ratgeber Für Administratoren
Software Management Operations
▀ Upgrading the Operating System Software
▄ Cisco ASR 5000 System Administration Guide
138
Configure a Newcall Policy
Configure a newcall policy from the Exec mode to meet your service requirements. When enabled the policy redirects
or rejects new calls in anticipation of the chassis reload that completes the upgrade process. This reduces the amount of
service disruption to subscribers caused by the system reload that completes the upgrade.
or rejects new calls in anticipation of the chassis reload that completes the upgrade process. This reduces the amount of
service disruption to subscribers caused by the system reload that completes the upgrade.
Important:
Newcall policies are created on a per-service basis. If you have multiple services running on the
chassis, you can configure multiple newcall policies.
The syntax for newcall policies is described below:
newcall policy { asngw-service | asnpc-service | sgsn-service } { all | name
service_name } reject
service_name } reject
newcall policy cscf-service { all | name service_name } { redirect
target_ip_address [ weight weight_num ] [ target_ipaddress2 [ weight weight_num ]
... target_ip_address16 [ weight weight_num ] | reject }
target_ip_address [ weight weight_num ] [ target_ipaddress2 [ weight weight_num ]
... target_ip_address16 [ weight weight_num ] | reject }
newcall policy { fa-service | lns-service | mipv6ha-service } { all | name
service_name } reject
service_name } reject
newcall policy { ha-service | pdsn-service} { all | name service_name } {
redirect target_ip_address [ weight weight_num ] [ target_ipaddress2 [ weight
weight_num ] ... target_ip_address16 [ weight weight_num ] |reject}
redirect target_ip_address [ weight weight_num ] [ target_ipaddress2 [ weight
weight_num ] ... target_ip_address16 [ weight weight_num ] |reject}
newcall policy ggsn-service {apn name apn_name | all | name service_name}reject
newcall policy hnbgw-service {all | name service_name}reject
newcall policy {pcc-af-service | pcc-policy-service} {all | name
service_name}reject
service_name}reject
newcall policy {pcc-af-service | pcc-policy-service} {all | name
service_name}reject
service_name}reject
newcall policy mme-service {all | name service_name } reject
For complete information about the above command, see the Exec Mode Commands chapter of the Command Line
Interface Reference.
Interface Reference.