Cisco Cisco Packet Data Gateway (PDG) Ratgeber Für Administratoren
Troubleshooting
Detecting Faulty Hardware ▀
Cisco ASR 5000 System Administration Guide ▄
203
Packet Processing Card Run/Fail LED States
The packet processing card Run/Fail LED indicates the overall status of the card. This LED should be green for normal
operation.
operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 20.
Packet Processing Card Run/Fail LED States
Color
Description
Troubleshooting
Green
Card powered with no
errors detected.
errors detected.
None needed.
Blinking
Green
Green
Card is initializing and/or
loading software.
loading software.
None needed.
Red
Card powered with
error(s) detected.
error(s) detected.
Errors were detected during the Power On Self Tests (POSTs). It is likely that the
errors were logged to the system's command line interface during the boot process.
errors were logged to the system's command line interface during the boot process.
Monitoring the System for show commands, the outputs of which will assist in further
determining the problem.
determining the problem.
System Logs for information on how to view logs.
The SNMP MIB Reference for information on associated status and alarm conditions.
None
Card is not receiving
power.
power.
Verify that the POWER LEDs on the PFUs are green. If they are not, refer to
for troubleshooting information.
Verify that the power source is supplying ample voltage and current to the chassis.
Verify that the card is properly installed per the instructions in the ASR 5000
Installation Guide.
Installation Guide.
If all of the above suggestions have been verified, it is possible that the packet
processing card is not functional. Please contact your service representative.
processing card is not functional. Please contact your service representative.
Packet Processing Card Active LED States
The Active LED on a packet processing card indicates that the software is loaded on the card and that the card is ready
for operation. When the system first boots up, all installed packet processing cards are booted into standby mode. The
system must then be configured as to which packet processing cards should serve as redundant components (remain in
standby mode) and which should function as active components.
for operation. When the system first boots up, all installed packet processing cards are booted into standby mode. The
system must then be configured as to which packet processing cards should serve as redundant components (remain in
standby mode) and which should function as active components.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.