Cisco Cisco Packet Data Gateway (PDG) Ratgeber Für Administratoren

Seite von 377
Session Recovery   
▀  Additional ASR 5x00 Hardware Requirements 
 
 
▄  Cisco ASR 5000 System Administration Guide 
314 
   
 
A best-effort attempt to recover various timer values such as call duration, absolute time, and others. 
 
The idle time timer is reset to zero and the re-registration timer is reset to its maximum value for HA sessions to 
provide a more conservative approach to session recovery. 
Important:
  Any partially connected calls (for example, a session where HA authentication was pending but has 
not yet been acknowledged by the AAA server) are not recovered when a failure occurs. 
Additional ASR 5x00 Hardware Requirements 
Because session recovery requires numerous hardware resources, such as memory, control processors, NPU processing 
capacity, some additional hardware may be required to ensure that enough resources are available to fully support this 
feature. 
Important:
  A minimum of four packet processing cards (three active and one standby) per individual chassis is 
required to use this feature. 
To allow for complete session recovery in the event of a hardware failure during a packet processing card migration, a 
minimum of three active packet processing cards and two standby packet processing cards should be deployed. 
To assist you in your network design and capacity planning, consider the following factors: 
 
Subscriber capacity is decreased depending on the hardware configuration. A fully configured chassis would 
experience a smaller decrease in subscriber capacity versus a minimally configured chassis. 
 
The amount by which control transaction processing capacity is reduced. 
 
The reduction in subscriber data throughput. 
 
The recovery time for a failed software task. 
 
The recovery time for a failed packet processing card. 
A packet processing card migration may temporarily impact session recovery as hardware resources (memory, 
processors, etc.) that may be needed are not available during the migration. To avoid this condition, a minimum of two 
standby packet processing cards should be configured.