Cisco Cisco Packet Data Gateway (PDG) Ratgeber Für Administratoren

Seite von 308
  Gy Interface Support 
Features and Terminology  ▀   
 
Cisco ASR 5x00 Home Agent Administration Guide  ▄  
 
   
205 
 
Terminating-IOI 
 
Time-Stamps 
 
Token-Text 
 
Trunk-Group-ID 
 
Type-Number 
 
User-Participating-Type 
 
User-Session-ID 
 
WAG-Address 
 
WAG-PLMN-Id 
 
WLAN-Information 
 
WLAN-Radio-Container 
 
WLAN-Session-Id 
 
WLAN-Technology 
 
WLAN-UE-Local-IPAddress 
PLMN and Time Zone Reporting 
For some implementations of online charging, the OCS requires the PCEF to reporting location-specific subscriber 
information. For certain subscriber types, subscriber information such as PLMN, Time Zone, and ULI can be sent over 
the Gy interface as the subscriber changes location, time zone, and serving networks to provide accurate online charging 
services. Such information can be reported independently from time and volume-based reporting. 
PLMN and Time Zone Reporting feature is enabled to support location event reporting based on triggers from Gx, when 
the following conditions are met: 
 
Session-based Gy is not initiated due to the absence of charging-actions in rulebase with Credit-Control enabled 
or due to delayed Gy session initiation. 
 
PLMN and Time Zone Reporting feature is either enabled in the credit control group or through the use of 
triggers received from Gx. 
If session-based Gy initiation fails or the session goes offline due to configuration or network issues, event-based Gy 
session will not be initiated. 
Important:
  Note that the failure-handling will not be supported for event-based Gy. 
Though, in event-based Gy, multiple events can be reported independently and simultaneously this is presently not 
supported. If an event occurs when the CCA-Event (CCA-E) of the previously reported event is awaited, then the new 
event is queued and reported only when a CCA-E is received or the message is timed out. 
To enable the PLMN and Time Zone Reporting feature, the PCRF shall send the Trigger AVP (Trigger Type 1, Trigger 
Type 2) at the command level in a CCA.  
The Event-based Gy session will be terminated in the following scenarios: 
 
On termination of the bearer/subscriber (subscriber level Gy).