Cisco Cisco Packet Data Gateway (PDG) Ratgeber Für Administratoren

Seite von 308
  MSID and PCF Zone Based Call Redirection 
Configuring MSID and PCF Zone Based Call Redirection  ▀   
 
Cisco ASR 5x00 Home Agent Administration Guide  ▄  
 
   
277 
Configuring MSID and PCF Zone Based Call Redirection 
This section describes the process of setting up MSID and PCF zone based call redirection from the command line 
interface. 
Caution:
  Incorrect configuration of the MSID and PCF Zone based Call Redirection features could result in 
sessions failing to be established. For example, if PDSN1 is configured to redirect sessions to PDSN2 while PDSN2 is 
configured to redirect sessions to PDSN1, a loop is created in which all sessions would fail to be connected. In addition, 
sessions will not be established if the PDSN to which the sessions are being redirected is unavailable. 
Configuring MSID Based Call Redirection 
To configure MSID based call redirection, you must create a new policy that defines a wildcard match list, a list of 
PDSNs to redirect to, and their respective weights. 
Important:
  Commands used in the configuration samples in this section provide base functionality to the extent 
that the most common or likely commands and/or keyword options are presented. In many cases, other optional 
commands and/or keyword options are available. Refer to the Command Line Interface Reference for complete 
information regarding all commands. 
Configure MSID based call redirection by applying the following example configuration: 
configure 
   context <context_name> 
      pdsn-service <pdsn_service_name
         policy msid-match <msid_with_wildcardsredirect <address
weight <weight_num> <address2weight <weight_num>...<address16weight 
<weight_num
         end 
Notes: 
 
You may repeat the policy msid-match command as needed, to a maximum of 16 wildcard MSIDs per PDSN 
service. 
Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode 
command 
save configuration
. For additional information on how to verify and save configuration files, refer to the 
System Administration Guide and the Command Line Interface Reference
Configuring PCF Zone Based Call Redirection 
To configure PCF zone based call redirection, you must create a new policy that defines a zone match list, a list of 
PDSNs to redirect to, and their respective weights.