Cisco Cisco Packet Data Gateway (PDG)

Seite von 421
Engineering Rules   
▀  CLI Session Rules 
 
 
▄  ASR 5500 System Administration Guide, StarOS Release 18 
356 
   
CLI Session Rules 
Multiple CLI session support is based on the amount of available memory. The Resource Manager reserves enough 
resources to support a minimum of six CLI sessions at all times. One of the six sessions is further reserved for use 
exclusively by a CLI session on an MIO/UMIO serial interface. 
Additional CLI sessions beyond the pre-reserved limit are permitted if sufficient MIO/UMIO resources are available. If 
the Resource Manager is unable to reserve resources for a CLI session beyond those that are pre-reserved, users with 
administrator-privileges are prompted to create the new CLI session, even without reserved resources. 
ASR 5500 Interface and Port Rules 
The rules discussed in this section pertain to the Ethernet ports used for subscriber traffic on the MIO/UMIO card (ports 
10 through 29). 
 
Give all logical interfaces a unique name to identify the interface from others in the same context. Logical 
interfaces in different contexts may have the same name. 
 
A single physical port can support multiple logical interfaces when you configure VLAN tags for that physical 
port. You can use VLAN tagging to bind a single physical port to multiple logical interfaces that reside in 
different contexts. 
 
Assign all logical interfaces a valid IP address and subnet. 
 
Give each logical interface within a context a unique IP address(es). Logical interfaces in different 
contexts can have the same IP address(es). 
 
If multi-homing is supported on the network, you can assign all logical interfaces a single primary IP 
address and up to 16 secondary IP addresses. 
 
You can configure a logical interface in only one context, but you can configure multiple interfaces (up to 512) 
in a single context. 
 
You can apply a maximum of 256 access control list (ACL) rules to a single logical interface. 
 
All ports are identified by their <slot#>/<port#>. 
 
Each physical port for subscriber traffic on an MIO/UMIO card may contain up to a maximum of 1,024 VLAN 
tags. 
 
A logical interface is limited to using a single VLAN on a single physical port, identified by its 
<card#/slot#/port#>. 
Packet Data Network (PDN) Interface Rules 
The following engineering rules apply to the interface to the packet data network (PDN): 
 
Configure the logical interfaces used to facilitate the PDN interface within the egress context. 
 
The default is to use a single interface within the egress context to facilitate the PDN interface. 
 
You can configure multiple interfaces in the egress context by using static routes or dynamic routing protocols. 
 
You may also configure next-hop default gateways.