Cisco Cisco Packet Data Interworking Function (PDIF)
Access Control Lists
▀ Applying IP ACLs
▄ ASR 5500 System Administration Guide, StarOS Release 17
214
Applying IP ACLs
Once an ACL is configured, it must be applied to take effect.
Important:
All ACLs should be configured and verified according to the instructions in the
prior to beginning these procedures. The procedures described below also assume that the subscribers
have been previously configured.
As discussed earlier, you can apply an ACL to any of the following:
Important:
ACLs must be configured in the same context in which the subscribers and/or interfaces to which
they are to be applied. Similarly, ACLs to be applied to a context must be configured in that context.
If ACLs are applied at multiple levels within a single context (such as an ACL is applied to an interface within the
context and another ACL is applied to the entire context), they will be processed as shown in the following figure and
table.
context and another ACL is applied to the entire context), they will be processed as shown in the following figure and
table.