Cisco Cisco Packet Data Gateway (PDG)
Troubleshooting
Detecting Faulty Hardware ▀
ASR 5500 System Administration Guide, StarOS Release 16 ▄
191
SSC Redundancy LED States
The Redundancy LED on the SSC indicates that software is loaded on the card, but it is serving as a standby component.
SSC support 1:1 redundancy; the Redundancy LED should be green on the other SSC for normal system operation.
SSC support 1:1 redundancy; the Redundancy LED should be green on the other SSC for normal system operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 30.
SSC Redundancy LED States
Color
Description
Troubleshooting
Green
Card is in standby mode
None needed. The other SSC should be in Standby mode.
Amber
Card is not backed up by the
standby SSC.
standby SSC.
Check the status of the other SSC. If one it has failed or has been removed from
the chassis, the system can continue to function but redundancy is
compromised.
the chassis, the system can continue to function but redundancy is
compromised.
Refer to Monitoring the System for information on determining the status of the
SSC and system software processes.
SSC and system software processes.
Blinking
Amber
Amber
Tasks or processes being
migrated from the active SSC to
the standby SSC.
migrated from the active SSC to
the standby SSC.
Refer to Monitoring the System for information on determining the status of the
SSC and system software processes.
SSC and system software processes.
None
Card is not receiving power.
OR
Card has failed.
OR
Card has failed.
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST test results are positive. If it is off, refer to the SSC Run/Fail LED States
section for troubleshooting information.
POST test results are positive. If it is off, refer to the SSC Run/Fail LED States
section for troubleshooting information.
SSC System Status LED States
The System Status LED on the SSC indicates the that there is a loss of service somewhere in the system. If this LED is
red, the system requires maintenance or service (for example, the system could not locate a a valid software image at
boot-up, or a high temperature condition exists).
red, the system requires maintenance or service (for example, the system could not locate a a valid software image at
boot-up, or a high temperature condition exists).
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information also provided to diagnose the problem.
information also provided to diagnose the problem.
Table 31.
SSC System Status LED States
Color
Description
Troubleshooting
Green
System is operating
normally
normally
None required.
Red
The system has
experienced a loss of
service.
experienced a loss of
service.
Refer to Monitoring the System for information on determining the status of system
hardware and software processes.
hardware and software processes.
None
Card is not receiving
power
power
Verify that the Run/Fail LED is green. If so, the card is receiving power and POST test
results are positive. If it is off, refer to the SSC Run/Fail LED States section for
troubleshooting information.
results are positive. If it is off, refer to the SSC Run/Fail LED States section for
troubleshooting information.