Cisco Cisco Packet Data Gateway (PDG)

Getting Started

▀ Configuring the Management Interface with a Second IP Address

▄ ASR 5500 System Administration Guide, StarOS Release 16

Configuring the Management Interface with a Second IP

Address

If necessary, you can configure a second IP address on the MIO management interface.

Step 1

Enter the configuration mode by entering the following command at the prompt:

[local]host_name# configure
[local]host_name(config)#

Step 2

Enter the following to enter the context configuration mode:

[local]host_name(config)# context local
[local]host-name(config-ctx)#

Step 3

Enter the interface slot number and port number by entering the following command:

[local]host_name(config-ctx)# 5/1
[local]host_name(config-if-eth)#

Step 4

Enter the secondary IP address and subnet mask by entering the following command:

[local]host_name(config-if-eth)# { ip | ipv } address ipaddress subnet_mask
secondary

Step 5

Exit the configuration mode by entering the following command:

[local]host_name(config-if-eth)# end

Step 6

Confirm the interface ip addresses by entering the following command:

[local]host_name# show config context local

The CLI output should look similar to this example:

config
context local
interface <interface_name>
ip address <ipaddress> <subnetmask>
ip address <ipaddress> <subnetmask> secondary
#exit

Step 7

Save your configuration as described in Verifying and Saving Your Configuration.