Cisco Cisco Packet Data Gateway (PDG)
Interchassis Session Recovery
▀ Configuring Interchassis Session Recovery (ICSR)
▄ ASR 5000 System Administration Guide, StarOS Release 18
360
The switchover control-outage-optimization CLI command allows new calls during the Accounting Flush, as soon as
the Audit is completed. This SRP Configuration mode command enables the quicker restoration of control traffic (call-
setup, modification, deletion) following an ICSR switchover.
the Audit is completed. This SRP Configuration mode command enables the quicker restoration of control traffic (call-
setup, modification, deletion) following an ICSR switchover.
configure
context context_name
service-redundancy-protocol
switchover control-outage-optimization
end
Configuring the SRP Context Interface Parameters
This procedure configures the communication interface with the IP address and port number within the SRP context.
This interface supports interchassis communication.
This interface supports interchassis communication.
Important:
CLI commands must be executed on both chassis. Log onto both chassis before continuing. Always
make configuration changes on the primary chassis first.
configure
context vpn_ctxt_name [-noconfirm]
interface srp_if_name
ip-address { ip_address | ip_address/mask }
exit
exit
port ethernet slot_num/port_num
description des_string
medium { auto | speed { 10 | 100 | 1000 } duplex { full | half } }
no shutdown
bind interface srp_if_name srp_ctxt_name
end
Verifying SRP Configuration
Verify that your SRP contexts were created and configured properly by running the show srp info command (Exec
Mode) on each chassis.
Mode) on each chassis.