Cisco Cisco Packet Data Gateway (PDG)
System Interfaces and Ports
Frame Relay Interfaces and Ports ▀
ASR 5000 System Administration Guide, StarOS Release 16 ▄
105
The default framing_type is SONET for the channelized line card.
With releases 8.1 and higher, we recommend that you include the signal type, either ds1 (24 timeslots, 1.536
Mbps) or e1 (32 timeslots, 2.048 Mbps), when defining the framing.
With releases 8.1 and higher, you need to set the service-type for the CLC card to frame-relay. All other options
are not fully supported at this time.
Configuring the Channel Characteristics
Use the following example to configure the path, framing, mapping, timeslots, and the Frame Relay interface and LMI
characteristics for a specific CLC/CLC2 port:
characteristics for a specific CLC/CLC2 port:
configure
port channelized <slot#>/<port#>
path <path_id> { ds1 | e1 } <number_of_connections> <frame_mapping>
<multiplex#> <multiplex#> framing <framing_mode> mapping-mode <mapping_mode> [
timeslots <timeslot#> [ <timeslot#> ] ]
<multiplex#> <multiplex#> framing <framing_mode> mapping-mode <mapping_mode> [
timeslots <timeslot#> [ <timeslot#> ] ]
Important:
You should record the path definition values you enter as the information will be needed again with
other configuration commands.
frame-relay path <path_id> { ds1 | e1 } <number_of_connections> [ timeslot
<timeslot#> [ intf-type <intf_type> [ lmi-type <lmi_type> ] ] ]
<timeslot#> [ intf-type <intf_type> [ lmi-type <lmi_type> ] ] ]
dlci path <path_id> { ds1 | e1 } <number_of_connections> { dlci <dlci_id> |
timeslot <timeslot#> }
timeslot <timeslot#> }
no shutdown
end
Binding a DLCI
Use the following procedure to bind the data link connection identifier (DLCI) to the channelized (Frame Relay) port.
Important:
This procedure should not be attempted until after the configuration is completed for Peer-NSEIs
and/or SS7 routing domains as described in the SGSN Administration Guide.
configure
port channelized <port#>
bind link { peer-nsei <nse_id> ns-vc-id <nsvc_id> | ss7-routing-domain
<ss7rd_id> linkset-id <id> link-id <id>}
<ss7rd_id> linkset-id <id> link-id <id>}
end