Cisco Cisco Packet Data Gateway (PDG)
rule-application
This command allows you to specify the purpose of a ruledef, such as for charging, post-processing, routing,
and so on.
and so on.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-acs-ruledef)#
Syntax Description
rule-application { charging | post-processing | routing | tpo }
no rule-application
no rule-application
no
Disables the rule application configuration.
charging
Specifies that the current ruledef is for charging purposes.
Up to 2,048 rule definitions can be defined for the charging application in an Active Charging Service.
Default: Enabled
post-processing
The post-processing keyword is available only in 8.3 and later releases.
Important
Specifies that the current ruledef is for post-processing purposes. This enables processing of packets even if
the rule matching for them has been disabled.
the rule matching for them has been disabled.
routing
Specifies that the current ruledef is for routing purposes. Up to 256 rule definitions can be defined for routing
in an Active Charging Service. Default: Disabled
in an Active Charging Service. Default: Disabled
Command Line Interface Reference, Modes A - B, StarOS Release 19
1169
ACS Ruledef Configuration Mode Commands
rule-application