Cisco Cisco Packet Data Gateway (PDG)
group-of-ruledefs-application
This command allows you to specify the purpose of setting up a group-of-ruledefs as either charging,
post-processing, or for other purposes.
post-processing, or for other purposes.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > ACS Group-of-Ruledefs Configuration
active-charging service service_name > group-of-ruledefs group_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-acs-group-of-ruledefs)#
Syntax Description
group-of-ruledefs-application { charging | content-filtering | gx-alias | post-processing | tpo }
no group-of-ruledefs-application
no group-of-ruledefs-application
no
If previously configured, deletes the group-of-ruledefs-application configuration from the current
group-of-ruledefs.
group-of-ruledefs.
charging
Specifies that the current group-of-ruledefs is for charging purposes.
content-filtering
Specifies that the current group-of-ruledefs is for content-filtering purposes.
gx-alias
Specifies that the current group-of-ruledefs is for Gx-alias purposes.
post-processing
Specifies that the current group-of-ruledefs is for post-processing purposes, that is, for use by the
post-processing CLI command or automatic name-matching to the Diameter Filter-Id AVPs.
post-processing CLI command or automatic name-matching to the Diameter Filter-Id AVPs.
Command Line Interface Reference, Modes A - B, StarOS Release 19
539
ACS Group-of-Ruledefs Configuration Mode Commands
group-of-ruledefs-application