Cisco Cisco Packet Data Gateway (PDG)
content-filtering flow-any-error
This command allows you to specify action to take on Content Filtering packets in the case of ACS error
scenarios.
scenarios.
Product
CF
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-rule-base)#
Syntax Description
content-filtering flow-any-error { deny | permit }
default content-filtering flow-any-error
default content-filtering flow-any-error
default
Configures this command with its default setting.
Default: permit
deny
Configures flow-any-error configuration as deny.
All the denied packets will be accounted for by the discarded-flow-content-id configuration in the Content
Filtering Policy Configuration Mode. This content ID will be used to generate UDRs for packets denied via
content filtering.
Filtering Policy Configuration Mode. This content ID will be used to generate UDRs for packets denied via
content filtering.
permit
Configures flow-any-error configuration as permit.
Usage Guidelines
Use this command to allow/discard content filtering packets in case of ACS error scenarios.
Examples
The following command allows content filtering packets in case of an ACS error:
content-filtering flow-any-error permit
content-filtering flow-any-error permit
Command Line Interface Reference, Modes A - B, StarOS Release 19
618
ACS Rulebase Configuration Mode Commands
content-filtering flow-any-error