Cisco Cisco Packet Data Gateway (PDG)
ip reset-tos
This command allows you to reset the IP Type of Service (ToS) value of incoming packets to the default QCI
value, before proceeding with the rest of ACS processing.
value, before proceeding with the rest of ACS processing.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-rule-base)#
Syntax Description
[ default | no ] ip reset-tos
default
Configures this command with its default setting.
Default: Disabled
no
If previously configured, deletes the IP reset-tos configuration from the current rulebase.
Usage Guidelines
Use this command to reset the ToS field of any packet after it reaches ACS, or to broaden the range of values
that are used in the ToS field in the IP header of any packet.
that are used in the ToS field in the IP header of any packet.
Command Line Interface Reference, Modes A - B, StarOS Release 19
690
ACS Rulebase Configuration Mode Commands
ip reset-tos