Cisco Cisco Tunnel Terminating Gateway (TTG)
policy-control dynamic-rule-limit
This command allows you to enable/disable per-dynamic-rule MBR policing—bandwidth limiting.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-acs)#
Syntax Description
{ default | no } policy-control dynamic-rule-limit
default
Configures this command with its default setting.
Default: Enable; by default, per-dynamic-rule MBR policing is enabled.
no
Disables per-dynamic-rule MBR policing.
Usage Guidelines
This command allows you to enable/disable per-dynamic-rule bandwidth limiting based on bitrates received
over Gx. Note that there are only two variants of this command, the default and no variants.
over Gx. Note that there are only two variants of this command, the default and no variants.
Command Line Interface Reference, Modes A - B, StarOS Release 19
490
ACS Configuration Mode Commands
policy-control dynamic-rule-limit