Cisco Cisco Packet Data Gateway (PDG)
path-failure clear-trap
Configures a trigger for clearing the path failure trap.
Product
ePDG
GGSN
P-GW
SAEGW
SGSN
S-GW
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > GTP-U Service Configuration
configure > context context_name > gtpu-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-gtpu-service)#
Syntax Description
path-failure clear-trap gtp echo
[ default | no ] path-failure clear-trap
[ default | no ] path-failure clear-trap
gtp echo
Sets the clearing trigger/trap to detect a failure upon reaching the maximum number of GTP-U echo message
retransmissions.
retransmissions.
default
Resets the command to its default setting of enabled.
no
Disables the feature.
Usage Guidelines
Use this command to set the detection policy for path failures. By default, path failure trap is cleared on
receiving first control plane message for that GTP-U peer allocation.
receiving first control plane message for that GTP-U peer allocation.
Command Line Interface Reference, Modes G - H, StarOS Release 19
1212
GTP-U Service Configuration Mode Commands
path-failure clear-trap