Cisco Cisco Packet Data Gateway (PDG)

Seite von 1630
udp-checksum
Inserts UDP-checksum in the UDP header of GTP-U packet.
Product
GGSN
HNB-GW
P-GW
SGSN
S-GW
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > GTP-U Service Configuration
configure > context context_name > gtpu-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-gtpu-service)#
Syntax Description
udp-checksum { no-optimize | optimize }
[ default | no ] udp-checksum
default
Through releases 14.0: Enables the UDP checksum, but no optimization is attempted. Releases 15.0 and later:
Enables the UDP checksum, and attempts optimization of the UDP checksum in UDP header of GTPU packet
using the inner payload transport checkusm.
no
Outer UDP checksum is marked as 'ZERO,' effectively disabling UDP checksum. Applicable only for IPv4
data.
no-optimize
No optimization attempt over UDP checksum in UDP header of GTP-U packet.
optimize
Attempts optimization of UDP checksum in UDP header of GTP-U packet using inner payload transport
checksum.
Command Line Interface Reference, Modes G - H, StarOS Release 19    
1221
GTP-U Service Configuration Mode Commands
udp-checksum