Cisco Cisco Packet Data Gateway (PDG)
nat-traversal
This command enables NAT traversal and also configures the forcing of UDP tunnels for NAT traversal.
Product
HA
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > HA Service Configuration
configure > context context_name > ha-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ha-service)#
Syntax Description
[ default | no ] nat-traversal [ force-accept ]
no
Disables NAT traversal or disables forcing the acceptance of UDP tunnels for NAT traversal.
default
Reset the defaults for this command.
Default: NAT traversal disabled, force-accept disabled.
force-accept
This keyword configures the HA to accept requests when NAT is not detected but the Force (F) bit is set in
the RRQ with the UDP Tunnel Request. By default this type of request is rejected if NAT is not detected.
the RRQ with the UDP Tunnel Request. By default this type of request is rejected if NAT is not detected.
Usage Guidelines
Use this command to enable NAT traversal and enable the forcing of UDP tunnels for NAT traversal.
Examples
The following command enables NAT traversal for the current HA service and forces the HA to accept UDP
tunnels for NAT traversal:
nat-traversal force-accept
tunnels for NAT traversal:
nat-traversal force-accept
Command Line Interface Reference, Modes G - H, StarOS Release 19
1271
HA Service Configuration Mode Commands
nat-traversal