Cisco Cisco Packet Data Gateway (PDG)

paging open-hnb

Configures paging optimization parameters for open HNBs connected through Hybrid Access mode in the
HNB-GW Global parameter.

This command is deprecated from release 16.0.

Important

Product

HNB-GW

Privilege

Security Administrator, Administrator

Command Modes

Exec > Global Configuration > HNB-GW Global Configuration

configure > hnbgw-global

Entering the above command sequence results in the following prompt:

[local]

host_name

(config-hnggw-global)#

Syntax Description

paging open-hnb [hnb-where-ue-registered fallback] {always | never | only-if-with-paging-area}
default paging open-hnb

default

Sets the default behavior of paging optimization configuration for an open HNB while using Open Access
mode support.

By default the HNB-GW pages open HNBs only if paging-area IE is received in the paging message.

{always | never | only-if-with-paging-area}

Sets the HNB-GW Global configuration instance to page open HNB for a paging message.

always: Sets the system to ALWAYS page the open HNBs irrespective of paging-area IE is received in
paging messages.

never: Sets the system to NEVER page any open HNB.

only-if-with-paging-area: Sets the system to page the open HNBs only when paging-area IE is received in
paging messages.

hnb-where-ue-registered fallback {always | never | only-if-with-paging-area}

Sets the HNB-GW Global configuration instance to page open HNB from where the UE is registered.

Command Line Interface Reference, Modes G - H, StarOS Release 19

1378

HNB-GW Global Configuration Mode Commands

paging open-hnb