Cisco Cisco Packet Data Gateway (PDG)
ip iuh-qos-dscp
Enables or disables the DSCP marking parameter for control and data packets transmitted over an IuH interface
towards HNB. By default this command is Disabled.
towards HNB. By default this command is Disabled.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > HNB-GW Service Configuration
configure > context context_name > hnbgw-service service_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-hnbgw-service)#
Syntax Description
ip iuh-qos-dscp protocol { sctp payload all | udp payload { gtpu | rtcp | rtp } } dscp_code
{ default | no } ip iuh-qos-dscp protocol { sctp payload all | udp payload { gtpu | rtcp | rtp } }
{ default | no } ip iuh-qos-dscp protocol { sctp payload all | udp payload { gtpu | rtcp | rtp } }
no
Use this keyword to set the configuration in pass-through mode. Use of this keyword is allowed even when
there is no previous DSCP parameter set.
there is no previous DSCP parameter set.
In this configuration the no keyword does not disable/remove a previous configuration.
Important
default
Enables the DSCP marking on HNB-GW and set/restores the QoS parameters to its default setting.
sctp payload all dscp_code
Specifies the QOS traffic pattern towards HNB in SCTP protocol association over IuH interface.
By this keyword the Traffic classes specified by a user based on SCTP protocol and all type of payload
identified based on the transport level port numbers.
identified based on the transport level port numbers.
By default DSCP codes cs5 is supported for all payloads in SCTP protocol.
udp payload { gtpu | rtcp| rtp} dscp_code
Specifies the QOS traffic pattern towards HNB in SCTP protocol association over IuH interface.
Command Line Interface Reference, Modes G - H, StarOS Release 19
1417
HNB-GW Service Configuration Mode Commands
ip iuh-qos-dscp