Cisco Cisco Packet Data Gateway (PDG)
only-if-with-paging-area: Sets the system to page the open HNBs only when paging-area IE is received in
paging messages.
paging messages.
hnb-where-ue-registered fallback
{always | never | only-if-with-paging-area}
Sets the HNB-GW service instance to page open HNB from where the UE is registered.
always: Sets the system to ALWAYS page the open HNBs from where the UE is registered. If the UE is not
registered then it pages the open HNBs irrespective of paging-area IE is received in paging messages.
registered then it pages the open HNBs irrespective of paging-area IE is received in paging messages.
never: Sets the system to page the open HNBs from where the UE is registered. If the UE is not registered
then it NEVER pages any open HNB.
then it NEVER pages any open HNB.
only-if-with-paging-area: Sets the system to ALWAYS page the open HNBs from where the UE is registered.
If the UE is not registered then it pages the open HNBs only when paging-area IE is received in paging
messages.
If the UE is not registered then it pages the open HNBs only when paging-area IE is received in paging
messages.
Usage Guidelines
Use this command to configure the paging optimization parameters for open HNBs connected through Open
Access mode in HNB-GW service instance.
Access mode in HNB-GW service instance.
Examples
The following command configures the HNB-GW service instance to page an open HNB from where the UE
is connected and paging-area IE is received in paging message:
paging open-hnb hnb-where-ue-registered fallback only-if-with-paging-area
is connected and paging-area IE is received in paging message:
paging open-hnb hnb-where-ue-registered fallback only-if-with-paging-area
Command Line Interface Reference, Modes G - H, StarOS Release 19
1432
HNB-GW Service Configuration Mode Commands
paging open-hnb