Cisco Cisco Packet Data Gateway (PDG)
gre
Configures Generic Routing Encapsulation (GRE) parameters for the A10 protocol within the HSGW service.
Product
HSGW
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > HSGW Service Configuration
configure > context context_name > hsgw-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-hsgw-service)#
Syntax Description
gre { checksum | checksum-verify | flow control [ action { disconnect-session | resume-session } ] [ timeout
msecs ] + | ip-header-dscp value { all-control-packets | setup-packets-only } | reorder-timeout msecs |
segmentation | sequence-mode { none | reorder } | sequence-numbers | threegppp2-ext-headers
qos-marking }
default gre { checksum | checksum-verify | flow-control | ip-header-dscp | reorder-timeout |
sequence-mode | sequence-numbers | threegppp2-ext-headers qos-marking }
no gre { checksum | checksum-verify | flow-control | ip-header-dscp | segmentation | sequence-numbers
qos-marking }
default gre { checksum | checksum-verify | flow-control | ip-header-dscp | reorder-timeout |
sequence-mode | sequence-numbers | threegppp2-ext-headers qos-marking }
no gre { checksum | checksum-verify | flow-control | ip-header-dscp | segmentation | sequence-numbers
| threegppp2-ext-headers qos-marking }
default
Restores the specified parameter to its default setting.
no
Disables the specified functionality.
checksum
Enables the introduction of the checksum field in outgoing GRE packets. Default: disabled
checksum-verify
Enables verification of the GRE checksum (if present) in incoming GRE packets. Default: disabled
flow-control [ action { disconnect-session | resume-session } ] [ timeout msecs
] +
Default: no GRE flow-control
Command Line Interface Reference, Modes G - H, StarOS Release 19
1547
HSGW Service Configuration Mode Commands
gre