Cisco Cisco Packet Data Gateway (PDG)
network-initiated-qos
Enables the use of network initiated QoS functionality.
Product
HSGW
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > HSGW Service Configuration
configure > context context_name > hsgw-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-hsgw-service)#
Syntax Description
[ default | no ] network-initiated-qos
default
Returns the command to its default setting of enabled.
no
Disables the ability to use network initiated QoS functionality.
Usage Guidelines
Use this command to enable or disable support for network initiated QoS functionality. Network initiated
QoS is enabled by default.
QoS is enabled by default.
When network initiated QoS functionality is enabled, if the vendor specific network control protocol (VSNCP)
protocol configuration options (PCO) arrive from the UE with the BCM set, the HSGW CCR-I includes the
Network-Request-Support AVP. If the PCRF behavior returns a BCM of MS+NW when this AVP is received,
then flows originating from the network (RSVP Resv) would be triggered upon a PCC-Rule install.
protocol configuration options (PCO) arrive from the UE with the BCM set, the HSGW CCR-I includes the
Network-Request-Support AVP. If the PCRF behavior returns a BCM of MS+NW when this AVP is received,
then flows originating from the network (RSVP Resv) would be triggered upon a PCC-Rule install.
Command Line Interface Reference, Modes G - H, StarOS Release 19
1556
HSGW Service Configuration Mode Commands
network-initiated-qos