Cisco Cisco Packet Data Gateway (PDG)
congestion-control overload-disconnect
This command enables and disables the policy for disconnecting passive calls (chassis-wide) during an overload
situation. It also configures and fine-tunes the overload-disconnect congestion control policy for an entire
chassis.
situation. It also configures and fine-tunes the overload-disconnect congestion control policy for an entire
chassis.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
congestion-control overload-disconnect [ iterations-per-stage integer | percent percentage_value | threshold
{ license-utilization percentage_value | max-sessions-per-service-utilization percentage_value | tolerance
number } ]
default congestion-control overload-disconnect [ iterations-per-stage | percent | threshold {
license-utilization | max-sessions-per-service-utilization | tolerance } ]
no congestion-control overload-disconnect
license-utilization | max-sessions-per-service-utilization | tolerance } ]
no congestion-control overload-disconnect
default
When "default" and one of the keywords is added to the command, the policy remains in its current state and
the value for the specified keyword is reset to its default value.
the value for the specified keyword is reset to its default value.
When "default" and the command are entered without keywords, the overload-disconnect policy for congestion
control is disabled.
control is disabled.
no
Disables the overload-disconnect policy for congestion control.
iterations-per-stage integer
Specifies the number of calls to be disconnected during the defined number of seconds. integer is a value
from 2 through 8. The default value is 8.
from 2 through 8. The default value is 8.
Command Line Interface Reference, Modes G - H, StarOS Release 19
145
Global Configuration Mode Commands (A-K)
congestion-control overload-disconnect