Cisco Cisco Packet Data Gateway (PDG)
sctp-param-template
This command allows you to create an SCTP parameter template and enter the SCTP Parameter Template
Configuration Mode. This mode is used to configure parameters for SCTP associations.
Configuration Mode. This mode is used to configure parameters for SCTP associations.
Product
MME
Privilege
Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
[ no ] sctp-param-template name
no
Removes the specified SCTP parameter template from the system.
name
Specifies the name of the SCTP parameter template being created or accessed. name must be an alphanumeric
string of 1 through 63 characters.
string of 1 through 63 characters.
Usage Guidelines
Use this command to enter the SCTP Parameter Template Configuration mode.
Entering this command results in the following prompt:
[
context_name
]
host
(sctp-param-template)#
SCTP Parameter Template Configuration Mode commands are defined in the SCTP Parameter Template
Configuration Mode Commands chapter.
Configuration Mode Commands chapter.
The SCTP parameters will be activated in a service only if the corresponding service restarts or if the
SCTP parameter template is re-associated with its corresponding service. The SCTP parameters will not
be active if the SCTP template is changed.
SCTP parameter template is re-associated with its corresponding service. The SCTP parameters will not
be active if the SCTP template is changed.
Important
Command Line Interface Reference, Modes G - H, StarOS Release 19
358
Global Configuration Mode Commands (L-S)
sctp-param-template