Cisco Cisco Packet Data Gateway (PDG)

threshold system-capacity

Configures alarm or alert thresholds based on the percentage of current system capacity.

Product

All

Privilege

Security Administrator, Administrator

Command Modes

Exec > Global Configuration

configure

Entering the above command sequence results in the following prompt:

[local]

host_name

(config)#

Syntax Description

threshold system high_thresh [ clear low_thresh ]

high_thresh

Default: 90

Specifies the high threshold system capacity percentage that must be met or exceeded within the polling
interval to generate an alert or alarm.

high_thresh is an integer from 0 through 100. A value of 0 disables the threshold.

clear low_thresh

Default: 90

Specifies the low threshold system capacity percentage that maintains a previously generated alarm condition.
If the number of sessions falls beneath the low threshold within the polling interval, a clear alarm will be
generated.

low_thresh is an integer from 0 through 100. A value of 0 disables the threshold.

This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.

Important

Usage Guidelines

Flash memory utilization thresholds generate alerts or alarms based on the system utilization.

Alerts or alarms are triggered for system capacity based on the following rules:

Command Line Interface Reference, Modes G - H, StarOS Release 19

914

Global Configuration Mode Commands (threshold ppp - url-blacklisting)

threshold system-capacity