Cisco Cisco Packet Data Gateway (PDG)
Crypto Template IKEv2-Dynamic Payload
Configuration Mode Commands
Configuration Mode Commands
The Crypto Template IKEv2-Dynamic Payload Configuration Mode is used to assign the correct IPSec
transform-set from a list of up to four different transform-sets, and to assign Mobile IP addresses. There
should be two payloads configured. The first must have a dynamic addressing scheme from which the
ChildSA gets a TIA address. The second payload supplies the ChildSA with a HoA, which is the default
setting for ip-address-allocation.
transform-set from a list of up to four different transform-sets, and to assign Mobile IP addresses. There
should be two payloads configured. The first must have a dynamic addressing scheme from which the
ChildSA gets a TIA address. The second payload supplies the ChildSA with a HoA, which is the default
setting for ip-address-allocation.
Command Modes
Exec > Global Configuration > Context Configuration > Crypto Template Configuration > Crypto Template
IKEv2-Dynamic Payload Configuration
IKEv2-Dynamic Payload Configuration
configure > context context_name > crypto template template_name ikev2-dynamic > payload
payload_name match childsa match { any | ipv4 | ipv6 }
payload_name match childsa match { any | ipv4 | ipv6 }
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(cfg-crypto-tmpl-ikev2-tunnel-payload)#
The commands or keywords/variables that are available are dependent on platform type, product version,
and installed license(s).
and installed license(s).
Important
•
•
•
•
•
•
•
•
•
Command Line Interface Reference, Modes C - D, StarOS Release 19
1269