Cisco Cisco Packet Data Gateway (PDG)
bad-request-weight
Sets a severity number for bad registration requests used in calculating a value for determining when to suspend
registration attempts.
registration attempts.
The system will ignore the configuration of this command unless the dos-prevention command has been
enabled.
enabled.
Important
Product
SCM (P-CSCF, A-BG)
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > CSCF Service Configuration > Proxy-CSCF
Configuration > CSCF Security Configuration
Configuration > CSCF Security Configuration
configure > context context_name > cscf service service_name > proxy-cscf > security-parameters
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-security-parameters)#
Syntax Description
bad-request-weight weight
default bad-request-weight
default bad-request-weight
default
Sets/restores the default value assigned to the specified command.
weight
Default: 2
Assigns a weight to a bad registration request. Defines the severity of a single bad request.
weight must be an integer from 1 to 5.
Usage Guidelines
Use this command to define the severity of bad registration request. This parameter is used in calculating the
current number of request failures to compare to the per-aor-failure-limit and the per-ip-failure-limit.
Configuring this command with a lower number causes the system to suspend registration attempts with
repeated request failures much sooner than when configured with a higher number.
current number of request failures to compare to the per-aor-failure-limit and the per-ip-failure-limit.
Configuring this command with a lower number causes the system to suspend registration attempts with
repeated request failures much sooner than when configured with a higher number.
Command Line Interface Reference, Modes C - D, StarOS Release 19
1596
CSCF Security Configuration Mode Commands
bad-request-weight