Cisco Cisco Packet Data Gateway (PDG)
host-select table
This command configures a table of peer servers associated with the Diameter host template.
Product
GGSN
HA
HSGW
IPSG
PDSN
P-GW
SCM
SAEGW
S-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Diameter Host Select Configuration
configure > diameter-host-template template_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-host-template)#
Syntax Description
In StarOS 14.1 and earlier releases:
host-select table { 1 | 2 | prefix-table { 1 | 2 } } algorithm { ip-address-modulus [ prefer-ipv4 | prefer-ipv6
] | msisdn-modulus | round-robin }
no host-select table
In StarOS 15.0 and later releases:
In StarOS 15.0 and later releases:
host-select table { 1 | 2 | range-table { 1 | 2 } } algorithm { ip-address-modulus [ prefer-ipv4 | prefer-ipv6
] | msisdn-modulus | round-robin }
no host-select table
no
Removes the table associated with the Diameter host template.
Command Line Interface Reference, Modes C - D, StarOS Release 19
1887
Diameter Host Select Configuration Mode Commands
host-select table