Cisco Cisco Packet Data Gateway (PDG)
redundancy
Configures the type of redundancy for a line card or SPIO. (ASR 5000 only)
Product
PDSN
FA
HA
GGSN
SSGN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Card Configuration
configure > card card_number
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-card-
slot_number
)#
Syntax Description
redundancy { aps-mode | card-mode | port-mode } [ -noconfirm ]
default redundancy [ -noconfirm ]
default redundancy [ -noconfirm ]
default
Restores redundancy to port-mode type redundancy.
aps-mode
This keyword works with SGSN only.
Important
Enables automatic protection switching (APS), if the card is either a CLC2 or an OLC2 line card with card
framing set to SONET. (Refer to the
framing set to SONET. (Refer to the
command.)
Enables multiplexed section (or switching) protection (MSP) type APS, if the card is a CLC2 line card with
card framing set to SDH. (Refer to the
card framing set to SDH. (Refer to the
command.)
Using this keyword with any card type other than a CLC2 or an OLC2 will take the card offline.
Important
Command Line Interface Reference, Modes C - D, StarOS Release 19
318
Card Configuration Mode Commands
redundancy