Cisco Cisco Packet Data Gateway (PDG)
ip rri-route
Configures High Availability (HA) IPv4 routing parameters for Reverse Route Injection (RRI). (VPC-VSM
only)
only)
Product
SecGW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
ip rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip virtual_ip_address } { ip_address |
next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
no ip rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip virtual_ip_address } { ip_address
| next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
no
Disables the specified RRI route.
network-mode { L2 | L3 }
Specifies the RRI route network mode type as Layer 2 (L2) or Layer 3 (L3).
clear_loopback_ip
Specifies the loopback address for clear traffic in IPv4 dotted-decimal notation.
rri-ip virtual_ip_address
Specifies the use of a virtual IP address on both Primary and Secondary for RRI. virtual_ip_address is expressed
in IPv4 dotted-decimal notation.
in IPv4 dotted-decimal notation.
ip_address
Specified in IPv4 dotted-decimal notation.
Command Line Interface Reference, Modes C - D, StarOS Release 19
735
Context Configuration Mode Commands I-M
ip rri-route