Cisco Cisco Packet Data Gateway (PDG)
radius trigger
This command enables specific RADIUS triggers. The RADIUS Trigger configuration in the Context
Configuration Mode is to enable backward compatibility. To configure RADIUS triggers for the default AAA
group, you must configure them in the Context Configuration Mode.
Configuration Mode is to enable backward compatibility. To configure RADIUS triggers for the default AAA
group, you must configure them in the Context Configuration Mode.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
[ no ] radius trigger { ms-timezone-change | qos-change | rai-change | rat-change | serving-node-change
| uli-change }
default radius trigger
no
Disables the specified RADIUS trigger.
default
Configures the default setting.
Default: All RADIUS triggers are enabled.
ms-timezone-change
Specifies to enable RADIUS trigger for MS time zone change.
qos-change
Specifies to enable RADIUS trigger for Quality of Service change.
Command Line Interface Reference, Modes C - D, StarOS Release 19
927
Context Configuration Mode Commands N-R
radius trigger