Cisco Cisco Packet Data Gateway (PDG)
map-to-application
This command allows to configure the P2P advertisement application that will map the advertisement group
to the corresponding application/protocol.
to the corresponding application/protocol.
Product
ADC
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > P2P Advertisement Server Group Configuration
active-charging service service_name > p2p-ads-group ads_group_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-acs-p2p-ads)#
Syntax Description
[ no ] map-to-application { p2p_list } +
no
If previously configured, disables the application/protocol mapping.
p2p_list
Specifies the list of protocols/applications supported in the P2P plugin.
+
More than one protocol/application supported in the P2P plugin can be entered within a single command.
Usage Guidelines
This command allows to configure the P2P advertisement application that will map the advertisement group
to the application protocol.
to the application protocol.
The maximum number of map-to-application rule lines that can be configured is equal to the number of the
applications present in p2p_list supported by P2P plugin.
applications present in p2p_list supported by P2P plugin.
Examples
The following command maps the ads-group to the slacker-radio application:
map-to-application slacker-radio
map-to-application slacker-radio
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1216
P2P Advertisement Server Group Configuration Mode Commands
map-to-application