Cisco Cisco Packet Data Gateway (PDG)
an-gw-address
This command defines a condition based on the IP address of Access Node Gateway (AN-GW) on which
subscriber is attached in an IP-CAN session.
subscriber is attached in an IP-CAN session.
Product
IPCF
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Condition Group
Configuration
Configuration
configure > context context_name > pcc-service service_name > condition group group_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-pcc-condition-group)#
Syntax Description
[ no ] an-gw-address
{
operator value angw_ip
/
mask
| {
in-range
|
!in-range
}
range_start_ip to
range_end_ip
}
[ no ] an-gw-address operator profile-attribute spr_attr_value
[ no ] an-gw-address operator subscription-attribute subs_prof_attr_value
[ no ] an-gw-address operator subscription-attribute subs_prof_attr_value
no
Removes the specified condition definition.
operator
Specifies how to logically match the information in the analyzed field.
operator must be one of the following:
• !=: Does not equal
• =: Equals
in-range
Specifies the condition to accept the IP address which are in range as argument to define the Access Node
Gateway address which is used by subscriber in IP-CAN session.
Gateway address which is used by subscriber in IP-CAN session.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1279
PCC-Condition-Group Configuration Mode Commands
an-gw-address