Cisco Cisco Packet Data Gateway (PDG)
proxy-lcp-authentication
Enables/disables proxy LCP authentication.
Product
PDSN
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > LNS Service Configuration
configure > context context_name > lns-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-lns-service)#
Syntax Description
[ no ] proxy-lcp-authentication
no
Disables the processing of proxy LCP authentication parameters from the LAC.
proxy-lcp-authentication
Default: Enabled
Enables the processing proxy LCP authentication parameters from the LAC.
Usage Guidelines
When enabled, if proxy LCP authentication parameters are received from the LAC and are acceptable, the
LNS resumes the PPP session from the authentication phase and goes to the IPCP phase.
LNS resumes the PPP session from the authentication phase and goes to the IPCP phase.
When disabled, PPP is always started from the LCP phase, ignoring and discarding any proxy LCP
authentication parameters received from the LAC. Disable this feature in situations where accept proxy LCP
Auth AVPs that the peer LAC sends should not be expected.
authentication parameters received from the LAC. Disable this feature in situations where accept proxy LCP
Auth AVPs that the peer LAC sends should not be expected.
Examples
Use the following command to disable the processing of proxy LCP authentication parameters from the LAC:
no proxy-lcp-authentication
no proxy-lcp-authentication
Use the following command to re-enable the processing of proxy LCP authentication parameters from the
LAC:
proxy-lcp-authentication
LAC:
proxy-lcp-authentication
Command Line Interface Reference, Modes I - Q, StarOS Release 19
505
LNS Service Configuration Mode Commands
proxy-lcp-authentication