Cisco Cisco Packet Data Gateway (PDG)
local-cause-code-mapping apn-not-supported-in-plmn-rat
This command maps the operator-preferred ESM/EMM cause code to be sent in Activation Reject messages
in place of the standard 3GPP Release 11 rejection cause #66 when activation of the requested APN is not
supported in current RAT and PLMN combination.
in place of the standard 3GPP Release 11 rejection cause #66 when activation of the requested APN is not
supported in current RAT and PLMN combination.
Product
MME
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-mme-service)#
Syntax Description
local-cause-code-mapping apn-not-supported-in-plmn-rat { { emm-cause-code emm_cause_number
esm-cause-code esm_cause_number [ attach ] [ tau ] } | esm-cause esm_cause_code esm-proc }
default local-cause-code-mapping apn-not-supported-in-plmn-rat [ attach | esm-proc | tau ]
esm-cause-code esm_cause_number [ attach ] [ tau ] } | esm-cause esm_cause_code esm-proc }
default local-cause-code-mapping apn-not-supported-in-plmn-rat [ attach | esm-proc | tau ]
default
Returns the cause code mapping to its default values. The default cause code values for Attach procedures
are emm-cause-code 19 and esm-cause-code 66. The default cause code values for TAU procedures are
emm-cause-code 15 and esm-cause-code 66 respectively. The default cause code for ESM procedure is 66.
are emm-cause-code 19 and esm-cause-code 66. The default cause code values for TAU procedures are
emm-cause-code 15 and esm-cause-code 66 respectively. The default cause code for ESM procedure is 66.
apn-not-supported-in-plmn-rat
The keyword apn-not-supported-in-plmn-rat specifies that the cause codes to be used for a rejection due
to the requested APN not being supported in the current RAT and PLMN combination are those that are
mapped in the configuration.
to the requested APN not being supported in the current RAT and PLMN combination are those that are
mapped in the configuration.
emm-cause-code emm_cause_number esm-cause-code esm_cause_number [ attach ] [ tau ]
MME only.
The keyword emm-cause-code configures the operator-preferred EMM cause code to be used if a NAS
Request is rejected due to this configuration.
Request is rejected due to this configuration.
• emm_cause_number specifies the EMM code replacement integer. The system accepts a value in the
range 0 through 255, however, the standards-compliant valid values are in the range 2 through 111.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
896
MME Service Configuration Mode Commands
local-cause-code-mapping apn-not-supported-in-plmn-rat