Cisco Cisco ASR 5000

Seite von 9109
ACS Charging Action Configuration Mode Commands   
▀  content-id 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
402 
   
content-id 
This command allows you to specify the content ID to use in the generated billing records, as well as the AVP used by 
the Credit Control Application, such as the “Rating-Group” AVP for use by the Diameter Credit Control Application 
(DCCA). 
Product
 
All 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration > Charging Action Configuration 
active-charging service service_name > charging-action charging_action_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-charging-action)# 
Syntax
 
content-id content_id 
no content-id 
no
 
Removes the content ID configuration from the charging action. 
content_id
 
Specifies the content ID for credit control service. 
In 12.1 and earlier releases 
content_id
 must be an integer from 1 through 65535. 
In 12.2 and later releases, 
content_id
 must be an integer from 1 through 2147483647. 
Usage 
This command specifies an optional content ID to use in the generated billing records. This identifier assists 
the carrier’s billing post processing and also used by credit-control system to use independent quotas for 
different value of 
content-id
If the specified ruledef uses the 
if-protocol
 command to select a value for content ID, then the 
content_id
 specified through this command is not used for billing record generation. 
Important:
  For more information on 
content-id
, refer to the 
if-protocol
 command in the ACS Ruledef 
Configuration Mode Commands chapter. 
Example
 
The following command sets the content ID in the current charging action to 
23
content-id 23