Cisco Cisco ASR 5000
ACS Charging Action Configuration Mode Commands
service-identifier ▀
Command Line Interface Reference, StarOS Release 18 ▄
431
service-identifier
This command allows you to configure the service identifier to use in the generated billing records, as well as the AVP
used by the Credit Control Application, such as the “Service-Identifier” AVP for use by DCCA. This is a more general
classifier than content-id.
used by the Credit Control Application, such as the “Service-Identifier” AVP for use by DCCA. This is a more general
classifier than content-id.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Charging Action Configuration
active-charging service service_name > charging-action charging_action_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-charging-action)#
Syntax
service-identifier service_id
no service-identifier
no
If previously configured, deletes the service ID configuration in the current charging action.
service_id
Specifies the service identifier.
In 12.1 and earlier releases
In 12.1 and earlier releases
service_id
must be an integer from 1 through 65535.
In 12.2 and later releases,
service_id
must be an integer from 1 through 2147483647.
Usage
Use this command to configure the service identifier to use in generated billing records, as well as the AVP
used by the Credit Control Application, such as the “Service-Identifier” AVP for use by DCCA. This is a
more general classifier than content-id.
used by the Credit Control Application, such as the “Service-Identifier” AVP for use by DCCA. This is a
more general classifier than content-id.
Example
The following command configures the service identifier in the current charging action to
99
:
service-identifier 99