Cisco Cisco ASR 5000
ACS Configuration Mode Commands
firewall flow-recovery ▀
Command Line Interface Reference, StarOS Release 18 ▄
479
firewall flow-recovery
This command allows you to configure the Stateful Firewall’s Flow Recovery feature.
Product
PSF
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs)#
Syntax
firewall flow-recovery { { downlink [ [ timeout timeout ] [ no-flow-creation ] + ] } | {
uplink [ timeout timeout ] } }
uplink [ timeout timeout ] } }
{ default | no } firewall flow-recovery { downlink | uplink }
default
Configures this command with its default setting.
Default: Downlink and uplink flow recovery enabled, 300 seconds
Default: Downlink and uplink flow recovery enabled, 300 seconds
no
Disables the flow recovery configuration.
downlink | uplink
Specifies the packets:
downlink
: Enables flow recovery for packets from the downlink direction.
uplink
: Enables flow recovery for packets from the uplink direction.
timeout timeout
Specifies the Stateful Firewall Flow Recovery Timeout setting, in seconds.
timeout
must be an integer from 1 through 86400.
Default: 300 seconds
no-flow-creation
Specifies not to create data session/flow-related information for downlink-initiated packets (from the Internet
to the subscriber) while the firewall downlink flow-recovery timer is running, but send to subscriber.
to the subscriber) while the firewall downlink flow-recovery timer is running, but send to subscriber.
Usage
Use this command to configure Stateful Firewall Flow Recovery feature.