Cisco Cisco ASR 5000
ACS Configuration Mode Commands
group-of-ruledefs ▀
Command Line Interface Reference, StarOS Release 18 ▄
503
group-of-ruledefs
This command allows you to create/configure/delete an ACS group-of-ruledefs.
Important:
In 14.1 and earlier releases, a maximum of 64 group-of-ruledefs can be configured in the active
charging service. In 15.0 and later releases, a maximum of 128 group-of-ruledefs can be configured.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs)#
Syntax
group-of-ruledefs ruledefs_group_name [ -noconfirm ]
no group-of-ruledefs ruledefs_group_name
no
If previously configured, deletes the specified group-of-ruledefs from the active charging service.
ruledefs_group_name
Specifies the group-of-ruledefs to add/configure/delete.
ruledefs_group_name
must be unique within the active charging service, and must be an alphanumeric
string of 1 through 63 characters. Each group-of-ruledefs must have a unique name.
If the named group-of-ruledefs does not exist, it is created, and the CLI mode changes to the ACS Group-of-
Ruledefs Configuration Mode wherein the group can be configured.
If the named group-of-ruledefs already exists, the CLI mode changes to the ACS Group-of-Ruledefs
Configuration Mode for that group.
If the named group-of-ruledefs does not exist, it is created, and the CLI mode changes to the ACS Group-of-
Ruledefs Configuration Mode wherein the group can be configured.
If the named group-of-ruledefs already exists, the CLI mode changes to the ACS Group-of-Ruledefs
Configuration Mode for that group.
-noconfirm
Specifies that the command must execute without prompting for confirmation.
Usage
Use this command to create/configure/delete a group-of-ruledefs.
A group-of-ruledefs is a collection of rule definitions to use in access policy creation.
On entering this command, the CLI prompt changes to:
A group-of-ruledefs is a collection of rule definitions to use in access policy creation.
On entering this command, the CLI prompt changes to:
[context_name]hostname(config-group-of-ruledefs)#
Also see the ACS Group-of-Ruledefs Configuration Mode Commands chapter.
Example