Cisco Cisco ASR 5000
Route-map Configuration Mode Commands
set origin ▀
Command Line Interface Reference, StarOS Release 18 ▄
8379
set origin
Sets the Border Gateway Protocol (BGP) origin code to a specified value. This command is for route maps that are used
with BGP routing only.
with BGP routing only.
Product
HA
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Route-map Configuration
configure > context context_name > route-map map_name { deny | permit }
seq_number
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-route-map)#
Syntax
[ no ] set origin { egp | igp | incomplete }
no
Disables setting the origin code.
egp
Sets the origin code to specify that the path is from a remote External Gateway Protocol (EGP) system.
igp
Sets the origin code to specify that the path is from a local Interior Gateway Protocol (IGP) system.
incomplete
Sets the origin code to specify that the path is from an unknown system.
Usage
Use this command to set a specified origin code for BGP.
Example
To set the origin code to be from an External Gateway Protocol (EGP) system, enter the following command:
set origin egp