Cisco Cisco ASR 5000
ACL Configuration Mode Commands
redirect css service (for downlink, by TCP/UDP packets) ▀
Command Line Interface Reference, StarOS Release 18 ▄
337
Important:
If the options specified do not exactly match an existing rule definition, the insertion point does not
change.
before
Indicates all rule definitions subsequent to this command are to be inserted before the command identified by
the exact options listed.
This moves the insertion point to be immediately before the rule definition which matches the exact options
specified such that new rule definitions will be added, in order, before the matching rule definition.
the exact options listed.
This moves the insertion point to be immediately before the rule definition which matches the exact options
specified such that new rule definitions will be added, in order, before the matching rule definition.
Important:
If the options specified do not exactly match an existing rule definition, the insertion point does not
change.
no
Removes the rule definition which exactly matches the options specified.
css service service_name
The name of the active charging service to which packets are to be redirected. At the executive mode prompt,
use the
use the
show active-charging service all
command to display the names of all configured charging
services.
service_name
must be an alphanumeric string from 1 through 15 characters.
downlink
Apply this rule definition only to packets in the downlink (from the Mobile Node) direction.
log
Default: packets are not logged.
Indicates all packets which match the redirect are to be logged.
Indicates all packets which match the redirect are to be logged.
tcp | udp
Specifies the redirect is to be applied to IP based transmission control protocol or the user datagram protocol.
tcp
: Redirect applies to TPC packets.
udp
: Redirect applies to UDP packets.
source_address
The IP address(es) from which the packet originated.
This option is used to filter all packets from a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this option. The range can then
be configured using the
This option is used to filter all packets from a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this option. The range can then
be configured using the
source_wildcard
parameter.
source_wildcard
This option is used in conjunction with the
source_address
option to specify a group of addresses for
which packets are to be filtered.
The mask must be entered as a complement:
The mask must be entered as a complement:
Zero-bits in this parameter mean that the corresponding bits configured for the
source_address
parameter must be identical.