Cisco Cisco ASR 5000
Global Configuration Mode Commands (A-K)
▀ fabric egress drop-threshold
▄ Command Line Interface Reference, StarOS Release 18
5406
fabric egress drop-threshold
Enables or disables the generation of a syslog event message when the number of egress Fabric Access Processor (FAP)
packet drops exceeds a set threshold within a window of time on an ASR 5500.
packet drops exceeds a set threshold within a window of time on an ASR 5500.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
fabric egress drop-threshold enable count number interval-secs seconds
fabric egress drop-threshold disable
disable
Disables the egress dropped-packet threshold settings. Settings are disabled by default.
enable
Enables the specified egress dropped-packet threshold settings. Settings are disabled by default.
count
number
Specifies the maximum number of egress traffic packets that can be dropped before a syslog event message is
generated. The count is specified as an integer from 10 through 5000.
generated. The count is specified as an integer from 10 through 5000.
interval-secs
seconds
Specifies the time interval (window) within which the maximum egress packet drop count can be exceeded.
The interval is specified in seconds as an integer from 30 through 600.
The interval is specified in seconds as an integer from 30 through 600.
Usage
Use this command to enable or disable the generation of a syslog event message when the number of egress
FAP packet drops exceeds a set threshold within a window of time on an ASR 5500.
When the threshold is exceed, the syslog event message is generated once, until the condition clears. Only
then will it be generated again.
By default this feature is disabled.
FAP packet drops exceeds a set threshold within a window of time on an ASR 5500.
When the threshold is exceed, the syslog event message is generated once, until the condition clears. Only
then will it be generated again.
By default this feature is disabled.
Example
The following command sets the egress FAP dropped-packet threshold at 2000 packets within a 60-second
window:
window:
fabric egress drop-threshold enable count 2000 interval-secs 60