Cisco Cisco Packet Data Gateway (PDG)
Call Control Profile Configuration Mode
authenticate detach ▀
Command Line Interface Reference, StarOS Release 18 ▄
1939
authenticate detach
Allows the operator to enable and define authentication for Detach procedures.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
authenticate detach [ access-type umts ]
[ no | remove ] authenticate detach [ access-type umts ]
no
Disables the defined authentication procedures configured for Detach Requests from the call control profile.
remove
Deletes the defined authentication procedures for Detach Requests from the call control profile configuration
file.
file.
access-type umts
Optionally, identifies the type of network access if the
access-type umts
keywords are included in the
command. By default, access-type UMTS is assumed.
Usage
Authentication for Detach procedures is disabled by default. This command enables/disables authentication
for a Detach Request and allows the operator to limit authentication based on the MS/UE access-type.
for a Detach Request and allows the operator to limit authentication based on the MS/UE access-type.
Example
The following command configures detach authentication to occur only for UMTS attached subscribers:
authenticate detach access-type umts
The following command disables authentication for all Detach Requests, use:
no authenticate detach