Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold system-capacity ▀
Command Line Interface Reference, StarOS Release 18 ▄
5965
threshold system-capacity
Configures alarm or alert thresholds based on the percentage of current system capacity.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold system high_thresh [ clear low_thresh ]
high_thresh
Default: 90
Specifies the high threshold system capacity percentage that must be met or exceeded within the polling
interval to generate an alert or alarm.
Specifies the high threshold system capacity percentage that must be met or exceeded within the polling
interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 100. A value of 0 disables the threshold.
clear
low_thresh
Default: 90
Specifies the low threshold system capacity percentage that maintains a previously generated alarm condition.
If the number of sessions falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
Specifies the low threshold system capacity percentage that maintains a previously generated alarm condition.
If the number of sessions falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
low_thresh
is an integer from 0 through 100. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Flash memory utilization thresholds generate alerts or alarms based on the system utilization.
Alerts or alarms are triggered for system capacity based on the following rules:
Alerts or alarms are triggered for system capacity based on the following rules:
Enter condition: Actual percentage of system capacity is greater than or equal to the high threshold.
Clear condition: Actual percentage of system capacity is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.
Example