Cisco Cisco Packet Data Gateway (PDG)

Seite von 9109
HNB-CS Network Configuration Mode Commands   
▀  map nri 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
6414 
   
map nri 
Configures the mapping of Network Resource Identifier (NRI) sent from UE to the MSC point code. This is an 
important configuration for CS network resource sharing over Iu-Flex interface. 
Product
 
HNB-GW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > HNB-CS Network Configuration 
configure > cs-network cs_instance
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-cs-network-instance_id)# 
Syntax
 
map nri range nri_start to nri_end point-code msc_point_code 
no map nri range nri_start to nri_end 
no
 
Removes the entries of mapping of range of NRIs received from UE with particular MSC point code. 
range nri_start
 
to
 
nri_end
 
Specifies the range of NRIs received from UE to map with pa articular MSC point code during initial CS core 
network node selection. 
nri_start
 is an integer from 0 through 1023 that should be less than 
nri_end
nri_end
 is an integer from 0 through 1023 that should be more than 
nri_start
The command can be entered more than once to map multiple NRI ranges to same MSC, but overlapping is 
not allowed. 
point-code msc_point_code
 
Specifies the SS7 address of the MSC in the CS network to map with a range of NRI values. 
point_code
 is an SS7 point code in dotted-decimal ###.###.### or 8-digit decimal ######## format. 
Usage 
Use this command to map a NRI received from UE during initial CS network node selection to MSC point 
code through NRI range mapping over Iu-Flex interface. 
This configuration is used during initial CS core network node selection when the network resource identifier 
(NRI) from the UE is available. The NRI range is mapped to MSC point code. This configuration is used 
when the core network uses Iu-Flex interface. 
The command can be entered more than once to map multiple NRI ranges to same MSC point code. 
It is possible to configure multiple ranges to more than one MSC however this configuration is required only 
when the CS core network is configured as Multi-Operator Core Network (MOCN).