Cisco Cisco Packet Data Gateway (PDG)
HNB-GW Service Configuration Mode Commands
handin ▀
Command Line Interface Reference, StarOS Release 18 ▄
6451
handin
Allows or disallows the incoming hand-over of an MS in HNB-GW via the Serving Radio Network Subsystem (SRNS)
Relocation procedure for the specified packet switched/circuit switched (PS/CS) core network (CN) domain.
Relocation procedure for the specified packet switched/circuit switched (PS/CS) core network (CN) domain.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HNB-GW Service Configuration
configure > context context_name > hnbgw-service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-hnbgw-service)#
Syntax
[ no | default ] handin cn-domain [ cs | ps ]
no
Disallows the incoming MS hand-over for the particular CN domain via SRNS Relocation procedure in an
HNB-GW service instance.
If hand-over is restricted the relocation request will be rejected with rejection cause “Relocation Not
Supported In Target RNC Or Target System”.
HNB-GW service instance.
If hand-over is restricted the relocation request will be rejected with rejection cause “Relocation Not
Supported In Target RNC Or Target System”.
default
Sets the HNB-GW service instance to allow the incoming MS hand-over for the particular CN domain via
SRNS Relocation procedure in an HNB-GW service instance.
SRNS Relocation procedure in an HNB-GW service instance.
cs
Sets the HNB-GW service instance to allow the incoming MS hand-over for the CS core network domain via
SRNS Relocation procedure in an HNB-GW service instance.
SRNS Relocation procedure in an HNB-GW service instance.
ps
Sets the HNB-GW service instance to allow the incoming MS hand-over for the PS core network domain via
SRNS Relocation procedure in an HNB-GW service instance.
SRNS Relocation procedure in an HNB-GW service instance.
Usage
Use this command to set HNB-GW service instance for allowing/disallowing incoming hand-over of an MS
in HNB-GW via SRNS Relocation procedure for PS or CS core network domain.
If hand-over is restricted the Relocation Request message will be rejected with rejection cause “Relocation
Not Supported In Target RNC Or Target System”.
in HNB-GW via SRNS Relocation procedure for PS or CS core network domain.
If hand-over is restricted the Relocation Request message will be rejected with rejection cause “Relocation
Not Supported In Target RNC Or Target System”.
Example
The following command configures the HNB-GW service instance to allow hand-over of an MS in HNB-W
via SRNS Relocation procedure for PS core network domain:
via SRNS Relocation procedure for PS core network domain: