Cisco Cisco Packet Data Gateway (PDG)
IPNE Service Configuration Mode Commands
▀ ipne-endpoint
▄ Command Line Interface Reference, StarOS Release 18
6642
ipne-endpoint
Creates and configures an IPNE endpoint and enters the IPNE endpoint configuration mode. An IPNE endpoint is a
combination of a local IPP address, a peer address and, optionally, a port.
combination of a local IPP address, a peer address and, optionally, a port.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IPNE Service Configuration
configure > context context_name > ipne-service ipne_service_name
Entering the above command sequence results in the following prompt:
[ context_name]host_name (config-ipne-service)#
Syntax
[ no ] ipne-endpoint
no
Causes the system to delete the IPNE endpoint configuration from the IPNE service configuration.
Usage
Use this command to create an IPNE endpoint and to enter the IPNE endpoint sub-configuration mode.
Example
Use the following command to access commands to configure the IPNE endpoint:
ipne-endpoint