Cisco Cisco Packet Data Gateway (PDG)
LTE Policy Configuration Mode Commands
paging-profile ▀
Command Line Interface Reference, StarOS Release 18 ▄
7175
paging-profile
Creates a paging profile or specifies an existing paging profile and enters the Paging Profile Configuration Mode.
Product
MME
ePDG
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration
configure > lte-policy
Entering the above command sequence results in the following prompt:
[local]host_name(lte-policy)#
Syntax
[ no ] paging-profile paging_profile_name [ -noconfirm ]
no
Remove the paging map from the system.
paging_profile_name
Specifies the name of the paging profile being created or accessed. If the profile name does not refer to an
existing profile, a new profile is created.
existing profile, a new profile is created.
paging_profile_name
must be an alphanumeric string of 1
through 64 characters.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage
Enter the Paging Profile Configuration Mode for an existing or newly defined paging profile. This command
is also used to remove an existing profile.
Entering this command results in the following prompt:
is also used to remove an existing profile.
Entering this command results in the following prompt:
hostname(paging-profile)#
Paging Profile Configuration Mode commands are defined in the LTE Paging Profile Configuration Mode
Commands chapter.
Refer to the Heuristic and Intelligent Paging chapter in the MME Administration Guide for more information
about Paging Profiles.
Commands chapter.
Refer to the Heuristic and Intelligent Paging chapter in the MME Administration Guide for more information
about Paging Profiles.
Example
The following command enters the existing Paging Profile Configuration Mode (or creates it if it does not
already exist) for the profile named
already exist) for the profile named
profile1
:
paging-profile profile1